Article Details

ID: 1479
Case Type: faq
Category: Device Programming
Related To: ispVM System
Family: All Devices

Search Answer Database

Why am I getting the error message "Failed to verify ID" during Full Scan using DL3A/B/C cable?

One will get the above error when the Device ID is not read back properly. The probable workarounds are,

1) Within the ispVM go to the pull down menu Project -> Project Settings, select Advanced and increase the TCK low pulse width to try slowing the clock.

2) Confirm the voltage levels of Vcc and GND on your board.

3) Check the instruction length to other non Lattice devices in case you have multiple devices on your board.

4) A 4.7K ohm pull-up resistor should be used on the TMS signal and a 4.7K ohm pull-down resistor on the TCK signal on the target board.


Like most websites, we use cookies and similar technologies to enhance your user experience. We also allow third parties to place cookies on our website. By continuing to use this website you consent to the use of cookies as described in our Cookie Policy.